Sakai SW800-II, Руководство по ремонту

Страница: 186 / 258

10-012
TROUBLESHOOTING
Example of blink code display
Example: Blink code 2-1-4
The lamp lights up 0.4 second twice, 0.8 second once and then 0.4 seconds four times.
SW880-11008
0.4 sec. 0.4 sec. 0.4 sec. 0.4 sec. 0.4 sec. 0.4 sec. 0.8 sec.
ENGINE CHECK lamp ON
ENGINE CHECK lamp OFF
2-2-2. Blink code list
Blink code
Description
Short (0.4 sec.) Long (0.8 sec.) Short (0.4 sec.)
1 1 1 CAN message, missing (message “RxCCVS”= cruise
control).
•
1 1 2 CAN message, missing (message “RxEngTemp”= engine
temperature).
•
1 1 5 CAN message, missing (message “SwtOut”= switch
outputs).
•
1 1 6 CAN message, missing (message “TCO1”= Speed signal). •
1 1 8 CAN message, missing (message “TSC1-AE”, “TSC1-DE”,
“TSC1-PE", “TSC1-TE” or “TSC1-VE”).
•
1 1 9 CAN message, missing (message “TSC1-AR”, “TSC1-DR”,
“TSC1-TR” or “TSC1-VR”).
•
1 2 3 Coolant temperature warning lamp, cable break or short
circuit.
•
1 2 6 Hand throttle, cable break, short circuit or signal implausible
compared to signal of idle sensor.
•
1 2 8 Charge air temperature sensor, cable break or short circuit. •
1 3 3 Sensor 1, cable break, short circuit or outside target range
with system reaction (temperature 1).
•
1 3 4 Rail pressure, positive or negative deviation (speed or flow
dependent) outside target range, pressure above target
range or implausible (leakage, injector needle blocked in
open position).
•
1 3 5 Metering unit valve, flow rate outside target range, not
connected or output disable or short circuit to Ubatt or
ground.
Oil pressure warning lamp, cable break or short circuit.
•
•
1 3 6 Air filter condition, pressure loss above target range with
system reaction.
•
1 3 7 Main relay, short circuit to Ubatt (relay 1). •
1 3 8 Main relay, short circuit to ground (relay 1). •
1 3 9 EMR internal error, watchdog counter exceeds maximum. •
1 4 2 Engine operating signal lamp, cable break or EMR internal
error.
•