Sakai SW800-II, Руководство по ремонту

Страница: 219 / 258

10-045
TROUBLESHOOTING
2-5-4. Continuous/automatic-vibration mode does not change
Reference Fig.: 2-5-1
Check point Check/Cause Action
1. Vibration Mode
Selector Switch
(1) When starter switch is ON, measure voltage between
vibration mode selector switch terminal 1 inlet wire YW
and chassis ground.
Standard voltage: 12 V or more
(2) When vibration mode selector switch is CONT and
starter switch is ON, measure voltage between vibration
mode selector switch terminal 3 outlet wire G and
chassis ground.
Standard voltage: 12 V or more
(3) When vibration mode selector switch is AUTO and
starter switch is ON, measure voltage between vibration
mode selector switch terminal 2 outlet wire P and
chassis ground.
Standard voltage: 12 V or more
If above item (1) is OK and item (2) or item (3) is NG,
vibration mode selector switch is faulty.
•
Replace vibration mode
selector switch.
2. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.