Sakai SW800-II, Руководство по ремонту

Страница: 217 / 258

10-043
TROUBLESHOOTING
2-5-3. Vibration frequency does not change 4/4
F-R lever vibrator switch must be ON.
Vibration mode selector switch must be CONT.
Reference Fig.: 2-5-1
Check point Check/Cause Action
5. Vibration Relay 3 Vibration frequency selector switch is in 4000.
(1) When starter switch is ON, measure voltage between
vibration relay 3 terminal c inlet wire GY and chassis
ground.
Standard voltage: 12 V or more
(2) When starter switch is ON, measure voltage between
vibration relay 3 terminal a inlet wire YR and chassis
ground.
There is no electricity in normal condition when
vibrator switch (F) is either High or Low and vibrator
switch (R) is Low.
Standard voltage: 12 V or more when vibrator switch
(F) is either High or Low and
vibrator switch (R) is High.
(3) When starter switch is ON, measure voltage between
vibration relay 3 terminal f outlet wire WL and chassis
ground.
There is no electricity in normal condition when
vibrator switch (F) is either High or Low and vibrator
switch (R) is High.
Standard voltage: 12 V or more when vibrator switch
(F) is either High or Low and
vibrator switch (R) is Low.
If above items (1) and (2) are OK and item (3) is NG,
vibration relay 3 is faulty.
•
•
•
•
•
Replace vibration
relay 3.
6. Harness Connecting
Between Terminals
Measure resistance of harness connecting between
terminals.
Standard resistance: 10 Ω or less
If resistance is abnormal, harness is faulty.
•
•
Repair or replace
harness.
•
•