Sakai SV540 Series, Инструкция по эксплуатации и обслуживанию

Страница: 54 / 108

2. OPERATION
– 48 – – 49 –
2.4 Vibratory Operation
1) Turn the engine speed select switch clockwise to set
the engine RPM to FULL or ECO.
NOTE: It is possible to conduct the rolling compactions as much
as the vibration specifications when setting the engine
speed select switch to FULL and ECO.
MID is fuel-efficient position called the "ECO MODE".
The ECO MODE is recommended when working on
flat road surfaces as the maximum speeds and the hill-
climbing performances are degraded.
Please conduct the rolling compactions by setting to the
FULL position when working on soft, steep sloped and
rugged road surfaces.
2) Use the vibrator switch
Ⓐ
installed at the control panel on the
top of the dashboard to select low or high amplitude and ON /
OFF of vibration.
" " position : Turning the vibrator switch clockwise causes the
vibration to start with high amplitude.
" " position : Vibration is shut down.
" " position : Turning the vibrator switch counter clockwise
causes vibration to start with low amplitude.
NOTE: For vibratory rolling, run the engine at FULL. or ECO.
Engine speed select switch
Vibrator switch
Ⓐ
2. OPERATION
– 48 –
2.3.6 Stopping the engine
1) Set the engine speed select switch at the IDLE
position, wait for about 5 minutes with the engine idling
to gradually cool the engine.
IMPORTANT
• Do not bring a hot engine to a sudden stop except for an emergency. This will
shorten the life of its component parts.
• Do not also allow an overheated engine to come to a sudden stop, but run it at
middle idling speed for gradual cooling down.
2) Turn the starter key to the " " position to stop the
engine.
CAUTION
Do not turn the starter switch " " position while
the machine is in motion.
3) Remove the starter key.
WARNING
• When dismounting from the machine, apply the brake by pressing the parking
switch button. If necessary to park on a grade, block the wheels to prevent
unexpected moving down the grade.
• Never fail to remove the starter key.
2.3.7 Check after stopping the engine
1) Perform the walk-around checks for oil and water leakage, abnormal signs around the
drums.
2) Fill the fuel tank.
3) Remove waste paper if any from the engine compartment, as this will pose a possible fire
hazard.
4) Scrape mud or other materials from and around the drums.
5) When transporting the machines, please ensure safety by strictly complying with the
applicable laws and regulations.
Engine speed select switch