Sakai SV540 Series, Инструкция по эксплуатации и обслуживанию

Страница: 38 / 108

2. OPERATION
– 32 – – 33 –
Vibrator switch
By means of vibrator switch located on the panel,
selection of vibration amplitude and On-Off is mode.
" " position : Turning the vibration switch clockwise causes
the vibration to start with high amplitude.
" " position : Vibration is shut down.
" " position : Turning the vibrator switch counter clockwise
causes vibration to start with low amplitude.
NOTE : For Vibratory rolling, run the engine at FULL and ECO.
Vibration selector switch
Selection can be mode between the vibrator switch
installed to the Foward - Neutral - Reverse (F-N-R) lever
and the other one located on the panel.
" " position : Vibration can be turned ON or OFF
with the switch located on the Foward -
Neutral - Reverse (F-N-R) lever. Pressing
this switch causes the vibration to start
and pressing it again to stop.
This vibration switch on the lever should
be used with the vibrator switch on the
panel placed at "
" or " " position.
"
CONT
" position : When the vibrator switch is set to the "
"or " " position, you can perform
vibration work without turning the
vibration switch ON and OFF.
NOTE : For vibratory rolling, run the engine at FULL and ECO.
IMPORTANT
• Do not operate the vibrator on a hard area such as cement concrete pavement
surface or the ground covered by thick steel sheets.
• Keep the vibrator stopped when the machine is at rest.
• Shut off the vibrator immediately when the machine has been caught in the mud
during vibratory operation.
Vibrator swich
Vibration selector swich
Vibration swich
2. OPERATION
– 32 –
Parking brake switch
If switch is pressed down, the parking brake will be
applied with the indicator lamp
P
on the dashboard lit up.
When pressed again, the brake is released and the
indicator lamp goes off.
NOTE: When pressing the parking brake switch during machine running, the brake is
activated and the engine is stopped at the same time. When starting the engine
again, shift the F-N-R lever back to the neutral position, set engine speed to idle,
activate the parking brake switch, and then start the engine.
WARNING
• To disengage the brake, be sure to press the button again instead of pulling it.
• Always press the button to apply the parking brake before dismounting from the
machine.
CAUTION
Never pull the switch up.
Horn switch button
Pressing the button at the center of the
steering wheel sounds the horn.