Sakai SV540 Series, Инструкция по эксплуатации и обслуживанию

Страница: 35 / 108

2. OPERATION
– 30 –
Engine check lamp
When the start switch is set to the " " position ,self-diagnosis
of the engine will start.
When the result is normal. Three lamps will goes out.
If the lamp remains lit or it lights during operation, it means
there is any trouble with the engine. Stop the machine to
check the engine.
★
ENGINE STOP
When the engine stop lamp lights, it means a serious
abnormality occurs with the engine. Stop the machine and
the engine, and receive proper checking / maintenance or
repairing.
★
WARNING
When the warning lamp lights, water may be accumulated in the fuel pre-filter.
Drain the fuel pre-filter (refer to page P.78).
If the lamp lights just because the water is accumulated in the fuel pre-filter, it will go out
after draining.
If the lamp does not go out, the engine may be abnormal. Receive proper checking /
maintenance or repairing before a serious failure occurs.
★
WAIT TO START
When the wait to start lamp is lit, it means self-diagnosis of the engine, and the engine
should not be started.
Must wait to start the engine. The most common reason for this is to wait for the intake air
heaters to complete a pre-heat cycle during cold ambient conditions.
IMPORTANT
For the details of the engine check lamp, see the instruction Manual of the engine.
Eco lamp
ECO lamp is turned on if the Engine speed select switch
is shifted to “ECO” position. It runs under the fuel-efficient
mode when the ECO lamp is turned on.
Normal vibrator speed occurs in ECO mode.