Sakai SV540 Series, Инструкция по эксплуатации и обслуживанию

Страница: 26 / 108

– 20 – – 21 –
WARNING: Negligence of these instructions can lead to accidents.
1.11 During Servicing
■
Keep unauthorized persons away
• During service, do not allow persons not concerned
to enter the work area, particularly when grinding or
welding operation is performed or heavy hammers are
being used.
■
Assume an appropriate posture while working
• An unnatural posture during maintenance work may cause injuries. Assume a posture that
is appropriate for the work being carried out.
■
Keep your machine clean
• Spilled oil, grease or scattered debris are dangerous. Always keep your machine clean.
Moisture that penetrates into the electrical system can cause malfunctions. Do not use
water to clean sensors, connectors and the operator’s station.
■
Take care not to get caught or crushed
• Be sure to fix the hood and other covers after opening them to prevent closing and avoid
getting caught in them.
• If there is a need to crawl under the machine after it has been lifted, be sure to support it
from underneath with a solid prop or block.
■
When repairing the electrical system
• Read the warnings in this manual regarding the
handling of batteries, and make sure to have a
thorough understanding in order to handle them
appropriately and safely.
• When repairing the electrical system or welding,
disconnect the negative cable from the battery to shut
off the electricity. Carrying out work while the cables
are connected to the negative terminal may cause
electrocution or explosions.
– 20 –
WARNING: Negligence of these instructions can lead to accidents.
■
Inspect or service your machine with the engine stopped
• If required to keep the engine running in such a case
as radiator interior cleaning, perform the work with
two persons. One of them should sit on the operator’s
seat getting ready for shutting down the engine. He
must take care not to touch any of controls carelessly.
Maintenance personnel must exercise extreme caution
not to make contact with moving parts.
■
Supplying fuel, oils and grease
• Do not cover the filler port when refueling. Feeding fuel in an airtight tank might damage
the fuel tank.
• Spilled fuel or oil will be slippery. Wipe up immediately. Keep the filler caps tight. Do not
use fuel for flushing oil. Handle fuel and oil in a well ventilated area.
■
Check the coolant level in the radiator
• To check the coolant level, stop the engine and allow the engine and radiator to cool
down before removing the radiator cap. Remove the cap by covering it with a rag before
removing to prevent any fluid that could spray under pressure from causing a burn.
■
Illumination
• For inspecting the level of the fuel, oil, coolant and
battery electrolyte, use explosion-proof illuminations.
Failure to use this type of illumination can result in an
explosion.
■
Make sure the gas dampers are properly maintained
• Before inspecting the engine room, make sure the gas dampers holding up the hood are
firmly engaged. Furthermore, in machines with stays to prevent the hood from closing,
make sure they are firmly in place.
■
Points to beware of when filling the sprinkler tank with water (on machines
equipped with a sprinkler tank)
• Do not fill the tank with the water inlet blocked. It may damage the sprinkler tank.