Sakai SV540 Series, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 108

– 6 – – 7 –
WARNING: Negligence of these instructions can lead to accidents.
■
Be careful with fire
• The fuel, oil, and anti-freeze will catch fire if open flames or
ignition sources are used close to them. Particularly, the fuel
is highly flammable.
• Do not smoke or use a match or cigarette lighter close to
inflammables (combustibles).
• When refueling, stop the engine and do not smoke.
• The filler caps of the fuel and oil tanks must be kept tight.
■
Ensuring safety in a fire
• Machine fires may cause serious injuries or death, so stop the engine by turning the starter
switch to the “OFF” position, then move away from the machine as quickly as possible.
■
While the engine is running or immediately after it has been turned off, do not touch
the muffler, exhaust pipe or DPF
• While the engine is running or immediately after it has been turned off, do not touch the
muffler, exhaust pipe or DPF, as they will be hot.
■
Mount on or dismount from your machine after it has come to a complete stop
• For getting on and off, face the machine and use the handrail and step.
• Watch your step when getting on or off the machine.
• Do not jump on or off a machine, particularly when it is moving.
■
Be careful not to fall
• Falling off the machine may cause serious injuries or death, so do not place your feet
anywhere other than on the steps, and in the driver’s seat.
■
Do not lock out yourself when leaving the machines
• Always bring the key with you by pulling it out from the starting switch when leaving the
machine.
– 6 –
WARNING: Negligence of these instructions can lead to accidents.
■
Do not use a machine which has not been serviced correctly at regular intervals
• Before working, perform necessary inspections. Start operation only after making
certain the machine is in good operating condition. If found to be abnormal, report to the
responsible person and have the fault corrected. Operate the machine after making sure
that it is safe to operate.
■
Do not allow anyone to enter the work area except for authorized personnel
• Always conduct the work paying attention to the
workers around the machine.
■
Beware when operating moving parts
• When operating moving parts such as covers, be sure to understand the way they move
and take care not to get the hands and feet caught.
■
Operator must sit in the seat when operating the machine
■
Be careful of hot parts
• After your machine has operated for some time, the
coolant, engine oil and hydraulic fluid will become hot
and the pressure will build up. If, in this state, you try to
remove the filler caps, drain the oil or replace the filters,
you can get burned. Perform this work in accordance with
the correct procedures with the machine cooled down.
• To remove the radiator cap, slowly loosen the cap to
relieve the pressure with the engine stopped and the
coolant cooled down (For the radiator cap with a lever,
lift the lever to release the trapped pressure).
• When removing the filler cap on the hydraulic tank, release the trapped pressure by
turning it out slowly to prevent the oil from gushing out (For the cap with a lever, lift the
lever to release the trapped pressure).
• While the engine is running or immediately after it has been stopped, do not touch the
engine, muffler, exhaust pipes, oil hydraulic pumps, oil hydraulic motors, lights, etc., as
they will be hot.
• Resin and metallic parts may become hot under direct sunlight on a hot day. Direct contact
with such parts may cause burns, so be sure to wear clothing and protective equipment
appropriate for the job.