Sakai SV204 Series, Инструкция по эксплуатации и обслуживанию

Страница: 54 / 100

2 OPERATION
– 48 –
2.4 Vibratory Operation
1) Run the engine at 1,800 rpm or higher by operating the
throttle lever.
2) Also, by means of vibration selector switch, the
selection can be made between the vibration switch
installed to the forward-reverse lever and the other one
located on the panel to the right of operator seat.
position : Vibration can be turned ON or OFF with
the switch located on the forward-reverse
lever. Pressing this switch causes the
vibration to start and pressing it again to
stop.
position : Vibration is shut down.
CONT position : Have this switch placed at this position
when vibration is not to be actuated.
3) Proper travel speed for vibratory compaction is
2–5 km/h, however, select speeds depending upon job
requirements.
IMPORTANT
• Keep the vibrator shut off when the machine is not rolling.
• Stop vibration if the machine has encountered a running difficulty, for example,
when it gets stuck in the mud.
NOTE: Rev up the engine when there is a big drop in its rate of revolution during rolling
compaction.