Sakai SV204 Series, Инструкция по эксплуатации и обслуживанию

Страница: 57 / 100

2 OPERATION
– 51 –
2.7 After Operation
Follow the procedures below to prevent the machine from falling into an unworkable condition
the following morning caused by muds and other extraneous matter on the drum, or frozen
drums:
1) Check to see if the engine coolant temperature is too high and the engine oil pressure is
not normal. Also check the fuel level.
2) Remove muds and water from the machine. Muds can get into the seals together with
water drops on the hydraulic cylinder piston rod. Damaged seals will result.
3) Park the machine on a hard and dry surface. If such a place is not available, cover the
ground with hard plates.
4) Low temperature will cause a significant reduction of battery efficiency. Cover batteries or
take them off from the machine and store in a warm place for the following day’s operation.
There is a danger of battery fluid leaking when removing the battery from the machine, so
take care not to tilt the battery when doing so.
IMPORTANT
Avoid carrying out high pressure cleaning around the meter panel or behind the
dashboard, as it may damage meters and other equipment.
2.8 Loading and Unloading
WARNING
• Use sturdy ramps with proper width, length and thickness which allow safe
loading and unloading.
• If the ramps deflect considerably under load, apply wooden blocks to reinforce
them.
• Loading should be conducted on a level and hard ground. Leave a sufficient
distance between the machine and the shoulder.
• To prevent slippage on the ramps, keep the drums free from mud, oils, etc. The
ramps must also be free of grease, oil and ice.
• Do not steer the machine on the ramps. If the machine is facing in the wrong
direction, allow it to dismount from the ramps and correct the direction.
For loading and unloading, use ramps or a proper loading stand.