RYTEC Turbo-Slide, Руководство пользователя

Страница: 14 / 50

6
PLANNED MAINTENANCE
—DAILY INSPECTION
Figure 13
Figure 14
Door Retention Inspection
Move the door to the fully closed position and then
verify that each door panel is properly positioned to
the respective door panel. Excessive pressure on the
door panel from the stay rollers can cause door
malfunction and premature wear of the gasket
system while not enough allows air infiltration,
increasing energy use.
Refer to “DOOR PANEL RETENTION SYSTEM” on
page 4 for additional information on the retention
system.
See “DOOR RETENTION/ STAY ROLLER-
DOOR BULB SEAL ADJUSTMENT” on page 15 for
adjustment procedures. (See Figures 15 and 16)
Figure 15
Figure 16
Door Operation Inspection
Run the door through four or five full open/close
cycles to make sure it is operating smoothly and
efficiently. There should be no binding or unusual
noises as the door travels across the head assembly.
Also, as the door opens and closes, verify that the
panels remain in contact with the door retention
system and seal properly.
IMPORTANT: DO NOT continue to operate the
door if it is not running properly.
This could further complicate any
problem.
Refer to “OPERATION” on page 3 for additional
information on control panel operation.
9” (R17-4” Thick Panel)
11” (R25-6” Thick Panel)
Rytec
Control
Panel
Rytec
Motor
Drive
Head
Assembly
Insulated
Rytec
Door
Panels
System 4
Control
Panel
Fused
Disconnect
Photo eyes
Stay
Rollers
Bi-Parting Door
Head
Assembly
Insulated
Rytec Door
Panel
Fused
Disconnect
System 4
Control
Panel
Photo eyes
Stay
Rollers
One-Way Door
Door Panel
Bottom
Sweeps
Door Panel
Bottom Sweeps
Door Jamb
Bulb Seal
Door Jamb
Bulb Seal
Drive Motor/
Gearbox
Assembly
Drive Motor/
Gearbox
Assembly
Anchor base
to concrete
through slots
Align stay roller
with door jamb
Door Opening
Wall
Stay Roller
Base
Approx:
9” (R17-4” Thick Panel)
11
” (R25-6” Thick Panel)
Standard F81 Stay Roller Bracket Placement
Anchor base
to concrete
through slots
Offset stay roller
from door jamb
Door
Opening
Wall
Stay Roller
Base for Right
Hand Door
F0091 Universal Cam Stay Roller Bracket Placement
Wall
Stay Roller
Base for Left
Hand Door
3/8”
TYP.