RDC6563F Standalone Fiber Cutting Control System User Manual V2.0
46
SHENZHEN RUIDA TECHNOLOGY CO., LTD
Move delay
If the parameter is 0, no delay will be made after the
idling otherwise the speed will be decelerated and
delayed after the idling.
Corner speed
The speed at which sharp corners are cut during cutting
is also the lowest speed during the entire cutting
process.
Corner
acceleration
Acceleration at sharp corners during cutting. If the
cornering speed and the cornering acceleration are set
too large, the cornering will be shaken. If the setting is
too small, the cutting speed will be affected. The
cornering acceleration is the minimum acceleration value
in the entire pattern cut.
cutting
acceleration
The highest acceleration value when the light is emitted
during the entire cutting process.
Cutting jerk
This parameter reflects the degree of change in
acceleration during the opening motion.
Move jerk
This parameter reflects the degree of change in
acceleration when the light is off.
Corner jerk
This parameter reflects how fast the curve bends when
cutting arcs of various curvatures.
LFS Frog Jump
Enable
When the leapfrog is enabled, one element is processed
to go to the next element, and when the cutting head
starts to lift, it begins to move when it is empty.
Otherwise, it is necessary to wait for the cutting head to
rise in place before starting the air movement.
Frog Jump
maximum distance
The maximum length of the leapfrog, the length of the
idling exceeds this value, and the leapfrog is not used.
Short distance No
rise enable
If the move less than the lift length, the cutting head does
not rise.
the length when it
is not rising
The maximum length of the idling that the cutting head
does not rise.
X-axis backlash
Backlash of the X axis. The value is set to 1um
depending on whether the machine actually has a
backlash. If the value is not zero, the board will
compensate for the backlash.
Y-axis backlash
Backlash of the Y axis. The value is set to 1um
depending on whether the machine actually has a
backlash. If the value is not zero, the board will
