RDC6563F Standalone Fiber Cutting Control System User Manual V2.0
51
SHENZHEN RUIDA TECHNOLOGY CO., LTD
negative pulses and pulse + direction. Generally set to
pulse + direction mode.
Motor step length
That is the pulse equivalent of the motor, when sending a
pulse to the motor, the absolute distance value
corresponding to the moving axis. Before the value is set
correctly, the machine can cut a large rectangle (larger
figure, which can make the error smaller), and calculate
the motor step by the length of the figure and the length
of the measurement automatically.
Work size
The farthest distance that the motion axis can move
depends on the actual conditions of the machine.
Home offset
If the axis is enabled with hardware limit protection, the
value should normally be set to 2~5mm. If it is set to 0,
when the motion axis runs to the minimum coordinate 0,
it is possible to make the limit valid, which will trigger
incorrectly. Hard limit protection for machine protection.
Maximum speed
The maximum speed of movement that the shaft can
withstand. This parameter is related to the driving
capability of the motor, the inertia of the moving shaft,
and the gear ratio.
Work start speed
The speed at which the motion axis starts directly from
the standstill state. If the value is too large, it will cause
the motor to lose step, jitter, and even whistle. If the
setting is too small, the running speed of the entire
graphic will be reduced. If the inertia of the moving shaft
is large (the shaft is heavy), a small take-off speed can
be set. If the inertia of the moving shaft is small (the shaft
is light), the take-off speed can be appropriately
increased. Typical values are 5 to 30 mm/s.
Manual start
speed
The starting speed of the movement of the axis on the
keyboard cannot higher than the starting speed of the
axis.
Maximum
acceleration
The maximum acceleration value of the motion axis
during acceleration and deceleration, the acceleration
setting is too large, which will also cause the motor to
lose motion, jitter and even whistle. If the setting is too
small, the acceleration will be slow and the running
speed of the whole graphic will be reduced. For a shaft
