RTS EKP-3016, Техническое руководство, Страница: 87 / 164

KP-3016/KP-3016A Series KP-3016/3016A Menu System 89
Bosch Security Systems, Inc. Technical Manual F.01U.315.927 Rev. 02
Filters
Filters allow you to add a bandpass filter, a preset frequency response (equalization) filter or a notch filter to one (1) or more
audio sources.
Bandpass
The Bandpass menu is used to enable using bandpass filters as well as set a low and high frequency range where
frequencies within the two (2) frequency points are passed and anything outside of the range is rejected.
IMPORTANT: OMNEO outputs are not available for the KP-3016A.
To configure a bandpass range for Inputs , do the following:
1.
Starting at the Audio Options|Advanced|Filters menu, select Bandpass .
2.
Press the SEL button .
Outputs appears in the panel display.
3.
Using the AUX/MENU shaft encoder, select Input .
4.
Press the SEL button .
OMNEO 1, and OMNEO 2 appear in the panel display.
NOTE: OMNEO 1 is only available if it is not the matrix connection.
5.
Using the AUX/MENU shaft encoder, select either OMNEO 1 or OMNEO 2 .
6.
Press the SEL button .
Frequencies and Mode appear in the panel display.
7.
Using the AUX/MENU shaft encoder, select Mode .
Disabled and Enabled appear in the panel display .
8.
Using the AUX/MENU shaft encoder, select Enabled .
9.
Press the SEL button .
An arrow appears next to the selected option .
10.
Press the CLR button.
Frequencies and Mode appear in the panel display .
11.
Using the AUX/MENU shaft encoder, select Frequencies .
12.
Press the SEL button .
The Low Freq scroll box and the High Freq scroll box appear in the panel display.
13.
Using the AUX/MENU encoder knob, select the low frequency you desire.
14.
Using the AUX/MENU shaft encoder, select the high frequency scroll box .
15.
Using the AUX/MENU encoder knob, select the high frequency you desire.
To configure a bandpass range for Outputs , do the following:
1.
Starting at the Audio Options|Advanced|Filters menu, select Bandpass .
Inputs and Outputs appears in the panel display.
2.
Using the AUX/MENU shaft encoder, select Output .
3.
Press the SEL button .
Headset, Matrix Out, OMNEO 1, and OMNEO 2 appear in the panel display.
NOTE: OMNEO 1 is only available if it is not the matrix connection. OMNEO is not available on the KP-3016A.