RTS EKP-3016, Техническое руководство, Страница: 26 / 164

28 Installation KP-3016/3016A Series
Bosch Security Systems, Inc. Technical Manual F.01U.315.927 Rev. 02
8.
Position both pieces of shrink-tubing so any portion of the cable without an outer insulation layer is covered.
9.
Using a heat gun, apply even heat over the length and diameter of the tubing (minimum temperature 100°C).
IMPORTANT: Since uncontrolled heat can cause uneven shrinkage, physical damage, and insulation failure, the use of
open flame is not recommended. Avoid overheating the heat shrink-tubing because it can become brittle
and/or charred.
10.
Gently push the headset connector cable back into the unit.
11.
Align the rib on the headset connector with the notch in the connector opening and press the connector
completely in.
12.
While holding the connector in place, turn the set screw clockwise to tighten the connector in position.