Roland LV-290, Руководство пользователя

Страница: 120 / 216

118
Bridge Cutting (Pen Page) [DEFAULT SETTING: Unselected / 0.0 mm]
Checking the Bridge Cutting checkbox will allow users to easily create perforation lines (dash-line). Once
seethe line color along with another corresponding pen can be used in tandem to indicate the length of the
gap and the uncut part of a perforation line. (If Pen 1 is selected for bridge cutting, Pen 9 will be reserved
to the length of the connected lines of the perforation. If Pen 2 is selected, Pen 10 will be reserved and so
on…)
5.2.3.3 LV-290 Printer Driver >> Advanced Page
Scaling (Advanced Page) [DEFAULT SETTING: 0]
In some cases you may find a slight output inaccuracy in the actual output compared to what you have set in
the computer. This margin of error or offset is extremely small (approximately 1/300). What this means is that
there may be a 1-unit offset for every 300 unit increments. As an example, if you engrave a 300mm straight
line, it may end up measuring only 299 mm or 301 mm in the final output. In this case, you will want to set
the scaling setting to +1/1000 or -1/1000 respectively to compensate. A general rule of thumb is for every
300 unit increment, you will want to adjust the slider by +1 if the final output is 1 unit increment shorter or -
1 if the final output is 1 unit increment longer than your graphic design setting.