RP248CN User’s and Installer’s Manual Page
6
Set time: [*]+[6]+[1]+[MASTER CODE]+[HH][MM]
Use a 24-Hour format. Hour and Minute should be two digits.
For example, if you want to entry 16:28, August 18, 2006, operate as:
[*]+[6]+[2]+[MASTER CODE]+[AUG][18][2006]
[*]+[6]+[1]+[MASTER CODE]+[16] [28]
3.7 Set follow-me numbers
(Refer to the chapter 6, section 6.5.6 for detail operation)
When alarm, RP248CN control panel can report the alarm events (burglar alarm, fire alarm,
rob alarm, emergency alarm) to one or several follow-me number(s) which has been set,
and distinguish different alarm events with different sound.
RP248CN has menu function for convenient operation. In normal state, depress
[*][2][7][master code][#] can entry into setting follow-me number and modify state. Up to 8 of
follow-me numbers can be set in the system. Depress [
←
][
→
] to move cursor left and right.
When setting follow-me number(s), should select the partition number first and then input
telephone number(s), and depress [#] to confirm.
3.8 Arm and arm sound
Quick arm
Any partition of RP248CN can be programmed or distinguished as stay partition and exterior
partition.
Key
[ARM]
for quick arm all zones/partitions of the system. Please leave away from all the
partitions during the delay time.
Key
[STAY]
for quick stay arm all of the exterior partitions/zones, and stay partitions/zones
would not be triggered. Please leave away from all the stay partitions / zones immediately.
Arm with code
There are two ways to arm RP248CN, quick arm and code arm. Default is quick arm. If
users need to code arm, please program the system as code arm function in advance. The
system should be armed by [master code] + [ARM], and be partitions armed by [master
code] + [STAY].
Arm sound
According to the default, after exit delay time, the system will make a sound to confirm the
system has entered into arm state. Cancel arm sound, please refer to chapter 6 section
6.5.2
3.9 Disarm and disarm sound
Disarm system
RP248CN can set several groups of 4 digits or 6 digits code in advance, one of them is
master code, and others for users. All of the code can disarm system.
Disarm sound
As the default, RP248CN will emit a long beep to confirm disarm successfully. Input [*]+[4]+
Steps Description
1
Check the disarm LED indicator. If on, the system can be
armed; if off, system can’t be armed, check whether every
partition is ready or there is any trouble.
2
Quick arm:
Quick arm: depress [ARM]
Quick stay arm: depress [STAY]
3
If operate incorrectly, the keypad will emit three short beeps, try
it again please
4
When arming, the keypad will beep until the end of exit delay
time. Please leave before end of exit delay. Default exit delay
time is 30s.
Steps Description
1
When entry into an armed zone, the keypad will emit beep
to warn the system exit delay is begin. The default delay
time is 30s.
2
disarm
Before end of entry delay, please input a code and [#] to
disarm, or else the system will alarm
If code incorrectly, the keypad will emit three short
beep. depress [*] and input code again.
3
Check keypad LCD display status:
“XXXXXX DISARMED”-- no alarm when armed;
“XXXX
：
ALARM/ NOV 01,07 18:15
→
”-- alarmed and
the alarm time.
4 Key
[
←
][
→
] use to check other alarmed events
