Roiscok RP248CN, Руководство пользователя и инсталлятора

Страница: 25 / 37

RP248CN Users and Installer’s Manual Page 24
system, connect a outer
SPST locked(not
instantaneous) key switch,
to any zone’s port, will
specify this type.
[3][2][0] EN.FOLL+STAY
When system keep STAY
arm , zone will same as
enter/exit extend time
zone, extended time for
enter and exit , will specify
by enter/ exit extend 1.
When system keep AWAY
arm , zone will same as:
enter into linkage ,will
produce instant in break
alarm when there is in
break in zone.
If there have already have
one exit/enter extend time
zone was inbreak, enter
into stay arm
zone, will keep
bypass ,until into extend
time close.
[3][2][1] KEY SW DLY
The same as zone type 17,
but have the specify time
for exit/enter extend time
1.
[3][2][2]
LTCH KSW
DLY
The same as zone type 19,
but have the specify time
for exit/enter extend time
1.
[4] Zone Sound
Each zone can set
different alarm sound
[4][1] Silent Alarm
When triggered, System
will report to CMS with
silent.
[4][2] Bell Only All Zones
Bell sound until the time is
over or enter the code to
disarm
[4][3] Buzzer Only
Only the Buzzer will be
triggered
[4][4] Bell+Buzzer
The bell and buzzer will be
triggered at the same time
[4][5] Door Chime
When disarmed, the
buzzer sound slowly as
soon as the zone is
triggered
[5] TERMINATION
Each zone can be defined
its terminal in difference,
NO/NC
[5][1] N/C Normal closed
[5][2] EOL All Zones
Single terminal resistor
(2200
Ω )
[5][3] DEOL
Double terminal resistors.
Used to distinguish the
different alarm type, such as
the detectors’ tamper)
[5][4] N/O Normal opened
[6]
LOOP
RESPONSE
Loop response time
[6][1] Normal YES 500 ms
[6][2] Long 1 sec
[6][3] Fast 10 ms
[7] Cross zones
When two zones are defined
as cross zone, they must be
triggered at certain interval
time the alarm will be
happen.
If choice “Ordered”, the first
zone must be triggered in
advance; If choice ”not
Ordered”, no triggered order
need
[7][1] NONE YES No cross zone
[7][2] ORDERED Trigger zones in order
[7][3]
NOT
ORDERED
Trigger zones in no order
Time Slot 1 second
Time range: 1-9
seconds
[8] Labels
ZONE01
ZONE02
Etc.
Edit the zone labels
[9] MAINTENANCE Maintenance
[9][1] Copy a Zone
Copy the zone’s data,
including type, terminal, loop
response, partition and
alarm sound
[9][2] Delete a Zone
Delete a zone and restore it
to default, then the zone