RP248CN Users and Installer’s Manual
Page 22
automatically that day.
Arm delay 225 second ,do not
adapt arm automatically.
NO: Any parts , arm
automatically will happen on
the set time
Programme exit delay time and
all hearable pre-alarm
[2][2][5] L.BATT.ARM
YES
YES: allow system arm when
spare battery have low
pressure
NO: not allow system arm when
spare battery have low
preesure.
[2][2][6] ENG.TAMPER
NO
YES: after tamper alarmed,
system will not ready arm ,and
TAMPER LED can not
recovery.
NO: after tamper alarmed,
system will stay ready state.
[2][2][7] BLANK
DISP
NO
YES: Display will show
information: “Enter code”.
After enter the code , recovery
display, and content shown on
the display will disappear after
1 minute, will recovery to
“BLANK”.
NO: Display normally.
[2][2][8] 24H
BYPASS
NO
YES: allow 24 hours zone
bypass
NO: not allow 24 hours zone
bypass.
[3] SET
CLOCK
Set Clock:
Set the system’s date and time
[3][1]
System D ATE
JAN 01 2000 Set system date
[3][2]
System Time
00:00
Input 24-hour time
[4] WINDOWING
The system will not send the
arm/disarm information to
central station, only display on
the keypad
[4][1] Window
Start
H:00
M:00
Set the start time
[4][2] Window
Stop
H:00
M:00
Set the stop time
[4][3]
Window Days
ALL
Set the start weekday(s)
[5] SYSTEM
LABEL
Set the system mark or
partitions mark
[5][0] Global
ROISCOK
System
mark
[5][1]-
[5][8]
Partitions 1 thru 8
PARTITION
1-8
Partitions 1-8 mark
[6] TAMPER
SOUND
BELL/ABUZ
/D
Set temper sound:
1. Silence
2. Bell
3. Keypad buzzer
4. Bell and buzzer
5. When arm start bell, when
disarm start buzzer
[7] DFLT
EN/DIS
ENABLE
ENABLE: all the system
parameters could be restored
to the default;
DISABLE: could not restore the
system parameters to the
default
[8] SERVICE
INFO
[8] [1]
SERV. NAME
ORBIT
SECURITY
[8] [2]
SERV. PHONE
SYSTEM
6.5.3 Set Zones
Depress [#] to zones, when the LCD displays as following. The data in the following table
are used for programming zones.
INSTALLER PROG
：
2)ZONE
→
Hot Key
LCD Display
Default Explanation
