RP248CN Users and Installer’s Manual
Page 26
the sensor can detector
be trigged.
Set a universal output port
as the power on/off switch
to supply power for the
noises (or shocks)
equipment. The following
is a relevant time table.
The starting time of the
first checking of
that day
should be set. From
that time on, the
system will do
re-checking in every
1-24 hrs interval by
turns.
During the checking, if all
the relevant sensors are
trigged, the relevant
information will be set to
the Alarm Center (make
sure a report code of this
event has been set in the
alarm center), which
means
Auto-Self-Checking has
been fulfilled successfully;
and about the time of this
event, it will be saved at
the Time Record of the
system
During the checking, in
case one or more
relevant sensors are
not trigged, a
“Auto-Self-Checking
Trouble” will be sent
to the Alarm Center;
and the trouble event
will be recorded in the
time table.
The
detailed
Auto-Self-Checking is
as follows :
Select Zones
ZONES FOR TEST
01) NONE
According to the
display,
press[ENTER], then
select 16 most likely
zones which are
needed be checked
LOCATION 01:
ZONE: 00 (00-96)
Input the first two
digits zone number; if
necessary, use the
[BPY]or [STAT] to
move the cursor, then
press[ENTER]; press
[ENTER] again to
repeat the above
operations and select
the next zone; keep
on this operation until
all the zones are
selected and make
sure all the zones
number are inputted
correctly; then
press[*] to end the
operation.
Time setting is in : 1)
SYSTEM then /1)
Time Setting then /7)
Zone time testing
TIME DEFINES:
7) Z. TEST TIMES
1) When you are at
/7)Zone time
testing, just press
[ENTER] to keep
on
ZONE TEST TIMES
1) START TEST AT:
2) Press [ENTER]
again
START TEST AT:
HOUR: 00 MIN: 00
3) Set the first testing
time (24 hours
form) at this step;
