Rohde & Schwarz SMC100A, Руководство по эксплуатации

Страница: 78 / 363

Manual Operation
R&S
®
SMC100A
61 Operating Manual 1411.4060.32 ─ 04
Moving the cursor on the display
► To move the cursor, use one of the following alternative methods:
a) Use the rotary knob or the arrow keys.
b) Use the "Winbar" key in the key emulation to toggle between the active dialogs.
c) Use the ESC key.
Tip: Be aware that the function of the ESC key depends on the current cursor position.
The function of this key depends on the current cursor position.
● Calls the next higher selection level.
● Closes the open window without accepting new entries; the old value or param-
eter is retained.
● In dialog boxes that contain a "Cancel" button it activates that button.
● Closes all kinds of dialog boxes, if the edit mode is not active.
● Quits the edit mode, if the edit mode is active.
● Switches between different entry fields of a menu.
● Shifts the entry cursor from the header display to the previously active menu, or
to the previously highlighted block in the block diagram if no menu is active.
Moving the coursor to the heading area
► Press the FREQ (CTRL+F) or LEVEL (CTRL+L) key to move the cursor to the header
area.
4.4.2 Selecting a Control Element
Control elements are always selected in the same way no matter whether a function block
in the diagram, a menu in the menu tree, a parameter in the menu or an entry in a list or
table is concerned.
► To activate an element, put the cursor on it.
An active element is highlighted by a blue frame.
4.4.3 Switching Parameters On/Off
A parameter can be activated and deactivated using a button or a check box.
1. Select the parameter.
2. To change the state of a parameter, use the "Enter" function of the different control
media:
● Press the rotary knob
● Press ENTER
Setting Parameters