Rohde & Schwarz SMC100A, Руководство по эксплуатации

Страница: 124 / 363

Instrument Function
R&S
®
SMC100A
107 Operating Manual 1411.4060.32 ─ 04
5.3.1.1 RF Output
To activate and deactivate the RF output signal, use one of the following alternatives:
●
by means of the RF ON/OFF key (the current entry focus is irrelevant)
●
by changing the state of the "RF" functional block (see
​
"State RF" on page 107)
●
by enabling/disabling the RF in the "Configure" menu of the "RF" block (see
​
"RF
Output State" on page 107).
The current state of the RF output (activated and deactivated) is indicated in the block
diagram by means of the different block color and the status of the "On" checkbox.
An active sweep is also indicated in the block.
To query the impedance of the RF outputs, use the command
​
:
​
OUTPut<hw>:
​
IMPedance
​
on page 233.
State RF
Activated/deactivates the RF output by changing the state of the "RF" functional block.
Alternatively, the RF ON/OFF key can be used.
SCPI command:
​
:
​
OUTPut<hw>[:
​
STATe]
​
on page 234
RF Output State
Activated/deactivates the RF output by enabling/disabling the RF in the "Configure" dia-
log of the "RF" block.
SCPI command:
​
:
​
OUTPut<hw>[:
​
STATe]
​
on page 234
5.3.1.2 Overview of the RF Signal Settings
The CW and Sweep modes are available for generating the RF signal.
●
CW
The RF signal is generated with the set frequency and level. This is the default mode.
●
Sweep
The RF signal is generated as a sweep with the set parameters.
It is not possible to activate frequency, level and LF sweep simultaneously.
RF Signal - RF Block