Rohde & Schwarz FSQ series, Быстрый старт

Страница: 74 / 229

R&S FSQ Preparing for Use
Setup
2.24 Quick Start Guide 1313.9652.62 - 02
When the selection is changed, the following settings are changed:
SCPI:
• The instrument will perform a preset.
71100C, 71200C, 71209A, 856xA/B, 856xE, 8591E, 8594E:
• The instrument will perform a preset.
The following instrument settings will then be changed:
IEC bus command:
SYST:LANG "SCPI" | "8560E" | "8561E" | "8562E" |
"8563E" | "8564E" | "8565E" | "8566A" | "8566B" |
"8568A" | "8568A_DC" | "8568B" | "8568B_DC" |
"8591E" | "8594E" | "71100C" | "71200C" | "71209A"
Model # of Trace
Points Start Freq. Stop Freq. Ref Level Input Coupling
8560E 601 0 Hz 2.9 GHz 0 dBm AC
8561E 601 0 Hz 6.5 GHz 0 dBm AC
8562E 601 0 Hz 13.2 GHz 0 dBm AC
8563E 601 0 Hz 26.5 GHz 0 dBm AC
8564E 601 0 Hz 40 GHz 0 dBm AC
8565E 601 0 Hz 50 GHz 0 dBm AC
8566A/B 1001 2 GHz 22 GHz 0 dBm DC (R&S FSQ)
AC (R&S FSP)
8568A/B 1001 0 Hz 1.5 GHz 0 dBm AC
8591E 401 0 Hz 3 GHz 0 dBm AC
8594E 401 0 Hz 3 GHz 0 dBm AC
71100C 1001 2 GHz 22 GHz 0 dBm DC (R&S FSQ)
AC (R&S FSP)
71200C 1001 2 GHz 22 GHz 0 dBm DC (R&S FSQ)
AC (R&S FSP)
71209A 1001 2 GHz 22 GHz 0 dBm DC (R&S FSQ)
AC (R&S FSP)
Note regarding the selection of 856x for the R&S FSQ:
• The # of trace points is not switched over until the state changes to
REMOTE. In the case of switchover to manual operation ( LOCAL
key), the number of sweep points is always changed to 625.
• If necessary, the stop frequency specified in the table is restricted to
the corresponding frequency range of the R&S FSQ.