Rohde & Schwarz FSQ series, Быстрый старт

Страница: 40 / 229

R&S FSQ Front and Rear Panel
Rear Panel Connections
1.12 Quick Start Guide 1313.9652.62 - 02
1.5 Rear Panel Connections
This section describes the rear connectors and interfaces of the R&S FSQ. Optional
connectors and interfaces are indicated by the option name in brackets.
AC Power Supply Connection and Main Power Switch
An AC power supply connector and main power switch are located in a unit on the rear panel
of the instrument.
Main power switch function:
GPIB Interface
The instrument comes with a GPIB interface in compliance with IEEE488. A controller for
remote control can be connected via this interface. Use a shielded cable to set up the
connection. For further information refer to the Operating Manual, chapter 8.
Printer Interface (LPT)
The 25-pin female LPT connector on the rear panel of the R&S FSQ is provided for connecting
a printer. The interface is compatible with the CENTRONICS interface. For further information
refer to the Operating Manual, chapter 8.
RS-232-C Interface (COM)
The instrument comes with an RS-232-C interface. The interface can be manually activated
and configured for remote control by defining the parameters in the
COM INTERFAC table,
which is accessed from the SETUP - GENERAL SETUP menu. For further information refer
to the Operating Manual, chapter 8.
Position I After being switched on, the instrument will be either in standby mode or in
operation depending on the setting of the ON/STANDBY switch on the front
panel of the instrument.
Position O Switching the instrument off disconnects the entire instrument from the AC
power supply.
The main power switch also interrupts the power supply of the OCXO
located in the instrument. When you switch the instrument back on, be
sure to comply with the extended warm-up phase specified in the data
sheet.