Rohde & Schwarz EVSG-B1, Руководство пользователя

Страница: 95 / 418

Numeric Measurement Modes
R&S
®
EVSG1000
95 User Manual 1178.6227.02 ─ 06
Status flags
The "STIOCPMV" value contains status flags, if applicable:
●
S : Start (started manually)
●
T : Triggered (externally)
●
I : Invalid
●
O : Overload (RF input signal too high)
●
C : Corrected (includes RF input correction factor)
●
P : PPS-synced
●
M : Morse ID available
●
V : Valid signal (ILS LOC/GP and VOR only)
4.2.3 Configuring ILS Marker Beacon Measurements
The following settings are available for the ILS Marker Beacon measurement.
Settings for recording, including trigger settings, are described in Chapter 8.2, "Record-
ing Measurement Data" , on page 217.
● Setting the Receiver Frequency ..............................................................................95
● Ampt ........................................................................................................................96
● Setting the Measurement Time (MTime) .................................................................97
4.2.3.1 Setting the Receiver Frequency
Access : [CH FREQ]
Access VNC : [q]
The receiver frequency determines the nominal frequency at which the measurement
is performed.
Freq ...............................................................................................................................95
Step Size .......................................................................................................................95
Freq
Sets the nominal frequency for the measurement.
Remote command:
RF
on page 245
Step Size
Defines the frequency step size for the rotary knob when setting the frequency.
The default step size for ILS MB mode is 50 kHz.
ILS Marker Beacon Mode (Option R&S EVSG-K3)