Rohde & Schwarz EVSG-B1, Руководство пользователя

Страница: 232 / 418

Common Instrument Settings
R&S
®
EVSG1000
232 User Manual 1178.6227.02 ─ 06
Example:
192.168.1.1
This setting is only required if the R&S EVSG1000 is installed in a network and the
instrument needs to communicate with other connected devices. For simple 1:1 con-
nections between the instrument and control PC, the setting is irrelevant.
Hostname
Unique instrument name in the network, as an alternative to the unique IP address.
Each instrument is delivered with an assigned instrument name, but this name can be
changed.
The default instrument name is a non-case-sensitive string with the following syntax:
<Type><variant>-<serial_number>
For example, EVSG1000-123456.
For information on determining the serial number, see Chapter 1.5.2.10, "Device ID" ,
on page 35.
Use the keypad to enter the name, see Table 1-6 .
Remote command:
GETHOSTNAME
on page 270
VNC Password
Enables or disables the requirement of a passwort to access the instrument remotely
via VNC.
After enabling the use of a password, you must reboot the R&S EVSG1000 before it
becomes active.
The password for VNC access is instrument . It cannot be changed.
Used IP Address
If "DHCP" is activated, the assigned IP address is displayed.
Used IP Netmask
If "DHCP" is activated, the assigned netmask is displayed.
Used IP Gateway
If "DHCP" is activated, the assigned gateway address is displayed.
9.5 System Settings
Access : [Setup] > "System"
Access VNC : [n] > [F5]
The following settings configure the general instrument system.
System Settings