Functional description of PRxx1 series controllers Rev.H.doc
2016-10-28
5/43
PRxx1 controller can register up to 1000 users plus 8 special ones called Guests. Each user has its
own ID number and may have proximity card and/or PIN. Controller firmware can be upgraded on-
site by means of RS485 serial interface and what is important the firmware upgrade process does
not require unit to be removed from its original place of installation. PRxx1 controllers can operate
fully autonomously (Standalone System) or in the Network System with or without CPR32-SE
network controller. PRxx1 controllers can be programmed manually or from PC. Manual
programming can be performed locally using the device’s keypad or from remote keypad located on
the external PRT series reader and connected to the programmed controller (the external reader
which is used to program controller should be equipped with keypad and configured to RACS
Clock&Data mode with ID0 address) – see III. Programming. Later, for some user programming
functions a so called Function Cards can be used. Remote programming can be done by means of
PR Master software (Roger) installed on PC.
The communication with single controller and management of the whole access control system
requires a dedicated interface device e.g.:
UT-4DR or UT-4 (RS485 <-> Ethernet).
UT-2USB (USB <-> RS485),
UT-2 (RS-232 <-> RS485),
RUD-1 (USB <-> RS485).
