Rockwell powerflex 700h, Руководство по программированию

Страница: 16 / 104

2-2 Programming and Parameters
No. Description
➊
File – Lists the major parameter file category.
➋
Group – Lists the parameter group within a file.
➌
No. – Parameter number. = Parameter value can not be changed until drive is stopped.
➍
Parameter Name & Description – Parameter name as it appears on an LCD HIM, with a brief
description of the parameters function.
➎
Values – Defines the various operating characteristics of the parameter. Three types exist.
ENUM Default:
Options:
Lists the value assigned at the factory. “Read Only” = no default.
Displays the programming selections available.
Bit Bit: Lists the bit place holder and definition for each bit.
Numeric Default:
Min/Max:
Units:
Lists the value assigned at the factory. “Read Only” = no default.
The range (lowest and highest setting) possible for the parameter.
Unit of measure and resolution as shown on the LCD HIM.
Important: Some parameters will have two unit values:
•
Analog inputs can be set for current or voltage with [Anlg In Config], param. 320.
•
Setting [Speed Units], parameter 79 selects Hz or RPM.
Important: When sending values through DPI ports, simply remove the decimal point
to arrive at the correct value (i.e. to send “5.00 Hz,” use “500”).
➏
Related – Lists parameters (if any) that interact with the selected parameter. The symbol “ ”
indicates that additional parameter information is available in Appendix B .
File Gr
oup
No. Parameter Name & Description
Values
Re
lat
ed
UTILI
T
Y
Drive
. .
.
198 [Load Frm Usr Set]
Loads a previously saved set of
parameter values from a selected user set
location in drive nonvolatile memory to
active drive memory.
Default:
Options:
0
0
1
2
3
“Ready”
“Ready”
“User Set 1”
“User Set 2”
“User Set 3”
199
Dia
gno
stics
216 [Dig In Status]
Status of the digital inputs.
Read Only 361
thru
366
MO
T
O
R
. . .
Motor D
ata
044 [Motor NP RPM]
Set to the motor nameplate rated RPM.
Default:
Min/Max:
Units:
1750.0 RPM
60.0/19200.0 RPM
1.0 RPM
0 0 0 0 0 0 x x x x x x x x x x
10 0 1 2 3 4 5 6 7 8 9 11 12 13 14 15
1 = Input Present
0 = Input Not Present
x = Reserved
Bit #
Digital In1 Digital In2 Digital In3 Digital In4 Digital In5 Digital In6
➊ ➌ ➋ ➏ ➎ ➍