Rockwell powerflex 700h, Руководство по программированию

Страница: 12 / 104

1-2 Start Up
Applying Power to the Drive
❏
4. Apply AC power and control voltages to the drive.
If any of the six digital inputs are configured to “Stop – CF”
(CF = Clear Fault) or “Enable,” verify that signals are present or
reconfigure [Digital Inx Sel]. If an I/O option is not installed (i.e. no I/O
terminal block), verify that [Digital Inx Sel] is not configured to “Stop –
CF” or “Enable.” If this is not done, the drive will not start. Refer to
Fault
& Alarm Descriptions on page 3-3 for a list of potential digital input
conflicts. If a fault code appears, refer to Chapter 3 .
❏
5. Proceed to Start-Up Routines.
Status Indicators Figure 1.1 Drive Status Indicators
# Name Color State Description
➊
PWR (Power) Green Steady Illuminates when power is applied to the drive.
➋
PORT Green – Status of DPI port internal communications (if present).
MOD Yellow – Status of communications module (when installed).
NET A Red – Status of network (if connected).
NET B Red – Status of secondary network (if connected).
➊
➋
Frame 9 shown