Robe DigitalSpot 3000 DT, Руководство пользователя

Страница: 11 / 113

DigitalSpot 3000 DT
11
The fixture must never be fixed swinging freely in the room.
Use 2 appropriate clamps to rig the fixture on a truss.
Make sure that the device is fixed properly!
Ensure that the structure (truss) to which you are attaching
the fixtures is secure.
A pair of the Omega holders can be placed in 2 positions on the bottom of the base. Use 2 clamps (not supplied)
with screws M12.
For overhead use, always install a safety cable that can hold at least 10 times the weight of the fixture. You must
only use safety cables with screw-on carbines. Pull the safety cable through the two apertures on the bottom of
the base and over the trussing system etc. Insert the end in the carbine and tighten the fixation screw.
To install the fixture on the truss:
1. Bolt clamp (1) to the omega
holder (2) with M12 bolt and lock nut through the
hole in the holder.
2. Fasten the omega holders on the
bottom of the base by inserting both quick-lock
fasteners (3) into the holes of the base and tighten
fully clockwise.
3. Fasten the safety-rope (4) through the
two apertures in the bottom of the base and over the
trussing system.
Before taking into operation for the first time,
the installation has to be approved by an expert!
We recommend avoiding dusty/smoky environments when operating the fixture. Usage in these environments may
cause a poor image quality. When using the projector under dusty or smoky conditions,dust may accumulate on a
lensor optical elements inside the projector. Such condition may degrade the quality of the projected image.