Robe DigitalSpot 3000 DT, Руководство пользователя

Страница: 81 / 113

DigitalSpot 3000 DT
81
31.4 Replacing the fuse
Only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, turn the power off and unplug the mains lead.
Procedure:
1) Unscrew the fuse holder on the rear panel of the base with a fitting screwdriver from the housing
(anti - clockwise).
2) Remove the old fuse from the fuse holder.
3) Install the new fuse in the fuse holder.
4) Replace the fuse holder in the housing and fix it.
31.5 System restore
You can perform a system restore on the DigitalSpot 3000 DT with your System Restore USB flash drive.
Warning.
The system restore replaces all fixture settings and the Media folder content.
This action return the device to a factory state.
For a system restore, you will need:
- the USB flash drive with a System restore utility (part of Digital 3000 DT delivery)
- the USB keyboard
Use the following steps to perform a system restore:
1 . Plug the USB flash drive with System restore utility and the USB keyboard into two external
USB ports on the DigitalSpot 3000 DT.
2 . Power on the DigitalSpot 3000 DT. When the fixture boots, press Delete key on the keyboard to enter the
fixture´s computer SETUP and set the boot from USB drive (Path: "Advanced Bios Features" --- >"1st boot device"---
-> "[USB]).
3. Save this setting and exit SETUP. The fixture continues booting, wait until you see a full-screen
menu titled:
Image Manager for ROBE Digital Products
Options:
Write "rescue" for enter to Main Menu
4 . Type the word rescue on the keyboard and the following screen will appear:
Options:
Restore From Backup
Restart
5 . Select option "Restore From Backup" to start recovery process This process will take cca 5 minutes.
6 . Select option "Restart" to restart the fixture. After a few minutes you may remove all your external USB devices.
Now the fixture is in a factory state and you should perform update (if required) of graphical software, HW
processors and media content to the current state.
31.6 Cleaning
Turn the power off and disconnect the fixture from the mains. before starting cleaning procedure.
It is absolutely essential that the fixture is kept clean and that dust, dirt and smoke-fluid residues must not build up
on or within the fixture. Otherwise, the fixture‘s light-output will be significantly reduced. Regular cleaning will not
only ensure the maximum light-output, but will also allow the fixture to function reliably throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recommended, under no circumstances should
alcohol or solvents be used!