DigitalSpot 3000 DT
23
Default Settings
--- Select this option to set default values or to remove user´s content in the fixture.
Set Default Values
--- Select this option to reset all fixture personalities to the default values.
Remove User Media Content
--- The item deletes all user media contents except the factory media
content.
15.4 Lamp On/Off
Use this option in order to switch on/off the projector´s lamp.Do not use the projector continuously for 24 hours or
more. If using the projector continuously for long periods, turn it off and leave it for one hour at least once during a
24 hour period.
15.5 Manual control
Manual DMX control ---
Select this menu to control all channels by the control elements on the control board.
Video Input Selection ---
This menu enables to select desired video input:
Internal input
External SVIDEO Input
15.6 Stand-alone setting
Use this menu to set options for a stand-alone mode as a selection of the playing program, programming and
modifying current programs.
Play program
--- Select this menu to run a built-in program or 10 freely-programmable programs
in a loop.
Test Program In Loop
--- The option starts built-in test program.
Program 1 In Loop
:
These options start user defined programs
Program 10 In Loop
Every program can run in two modes:
Norma
l - This mode uses pan/tilt movement and therefore is good
for a dynamic projection.
Static
- This mode is suitable for projections on the wall, ceiling or
ground without any head movement. By means of items
Pan, Tilt and Focus is possible to adjust moving head
to the desired position.
Running program is possible to pause by pressing the [ENTER] button.
Edit Program
--- Select this menu to edit or create a program. The DigitalSpot 3000 DT has 10 freely-programmable
programs, each up to 99 steps. Each program step has a step time, during which effects last in a current step.
Procedure:
1. Select the program you want to edit (“Program 1” - “Program 10”) and press the [ENTER] button.
2. Select “Edit Steps” menu and press [ENTER] button.
3. Select the desired program step (“Step 01” - “Step 99”) and press [ENTER] button.
4. Select the desired item and press the [ENTER] button. Now you can edit a DMX value of selected item by the
[RNS] encoder wheel
5. Press the [ENTER] to save adjusted value.
6. Select another effects (channels) and repeat steps 4 an 5.
7. Select “Save” or “Save and Copy” and press the [Enter] to confirm all adjusted values in a current step:
“Save” -
saves the current prog. step
“Save and Copy” -
saves and copies the current prog. step to the next prog. step.
Option
“Snap DMX”-
inserts current values from DMX to all effects (channels). It is very useful function, you don
not have to adjust all effects to desired positions, all values are loaded from DMX.
8. Go to the next prog. step ,press the [ENTER] and repeat this procedure (steps 4 and 7).
After creation of the program, you can simply reduced its length (by changing the start/end step) using either
“
Start Step
” item or “
End Step
” item.
Содержание DigitalSpot 3000 DT
Страница 1: ...Version 1 7 ...
