DigitalSpot 3000 DT
78
31. Maintenance
31.1 Replacing the lamp
Turn the power off and disconnect the fixture from the mains. If the lamp is
hot, avoid burns by waiting for approximately 45 minutes until the lamp has cooled.
1. Remove the top cover (1) of the fixture head by loosening
the four quarter-turn fasteners (2).
2. Remove the lamp cover (4) by loosening screw (3).
Do not turn the power on with the lamp cover
removed.
3. Loosen the screw (5) that secures the lamp.
Lift the handle (6) so that it stands up. Use the
handle to slowly pull the lamp out of the
projector.
Note: Pulling it too quickly may cause the lamp to break
and scatter broken glass in the projector.
Do not insert your hands into the projector after
the lamp is removed. If you touch the optical
components inside, it could cause colour
unevenness and distortion of the projected
images.
4. As shown in details, lower the new lamp
first into the connector on the projector and
align the two holes on the projector.
Tighten the screw (5) that secures the lamp.
Loose screw may cause a bad connection, which
could result in malfunction.
Do not over tighten the screw.
5. Place the lamp cover (4) back and tighten the screw (3)
Cover the fixture head.
6. Switch on the the fixture and reset the counter "Resetable
Hours” in the "Lamp on Time” menu.
Содержание DigitalSpot 3000 DT
Страница 1: ...Version 1 7 ...