DigitalSpot 3000 DT
76
30. Error and information messages
The warning icon (triangle) on the bottom-right side of the fixture´s screen indicates some error or information
message which appears on the screen by pressing the [ESC] button.
Pan Error
The message will appear after the reset of the fixture if the yoke´s magnetic-indexing circuit malfunctions (sensor
failed or magnet is missing) or the stepping motor is defective or its driving IC3 on the PCB in the fixture base. The
yoke is not located in the default position after the reset of the fixture.
Tilt Error
The message will appear after the reset of the fixture if the head´s magnetic-indexing circuit malfunctions (sensor
failed or magnet is missing) or the stepping motor is defective or its driving IC3 on the PCB in the fixture base. The
head is not located in the default position after the reset of the fixture.
Focus Error
The message will appear after the reset of the fixture if the focus module´s magnetic-indexing circuit malfunctions
(sensor failed or magnet is missing) or the stepping motor is defective or its driving IC1 on the PCB in the fixture
head. The focus is not located in the default position after the reset of the fixture.
Shutter Error
The message will appear after the reset of the fixture if the shutter´s magnetic-indexing circuit malfunctions
(sensor failed or magnet is missing) or the stepping motor is defective or its driving IC1 on the PCB in the fixture
head. The shutter lamella is not located in the default position after the reset of the fixture.
Power Down Mode
The fixture is in " power down mode"- this mode omits fixture reset after switching it on, and reduces the power
of motors. “Power down mode” is useful in special cases e. g. if the fixture is in a flight case and you want to set its
DMX address without taking it out from the case. To enter „Power down mode”, press and hold [ENTER] button
and at the same time switch on the power switch.
Now you can set DMX address and behaviour of the fixture by using menu “Personality”. If you want to go to a
“normal operation mode”, run a total fixture reset
.
Please Clean Air Filters
The message warns you that the time interval adjusted in the menu item Time To Cleanup Filters in the Service
menu has expired and you should clean fixture´s air filters.
Please Update HW Processors in Menu "Special Functions"
Run update of the hardware functions - see chapter "Special functions".
LED Temperature Sensor Open
The message informs you that there is not communication between the sensor measuring the temperature of the
LED module and the control PCB. This connection is broken.
LED Temperature Sensor Short
The message informs you that there is not communication between the sensor measuring the temperature of the
LED module and the control PCB. This connection is in short circuit.
Dataprojector Temp. Read Error
System message from dataprojector.
Dataprojector Power Failure
System message from dataprojector.
Содержание DigitalSpot 3000 DT
Страница 1: ...Version 1 7 ...
