DigitalSpot 3000 DT
79
31.2 Replacing the projector
If you need to remove the data projector, turn the power off and disconnect the DigitalSpot 3000 DT from the
mains. If the projector lamp is on, wait 25 minutes until the projector has cooled.
1. Remove both covers (1) of the fixture head (2) by loosening
the four quarter-turn fasteners (3) on each cover.
2. Remove the rear cover (4) by loosening four side screws (5)
and four screws (6) on the rear side. Disconnect all power and data
cables (7) from rear panel of the projector.
3. Bow the head and loosen the four screws (9) on the bottom side of
the head that fastening the projector chassis (10) to the fixture head.
Warning:
The projector can fall out from the head if all fixing screws (9) are
missing from chassis.
4. Unscrew two fastening screws (8) which securing the focus
driving motor and lift off this motor.
Carefully take the projector (11) with chassis (10) out from
the head.
Содержание DigitalSpot 3000 DT
Страница 1: ...Version 1 7 ...