Riverbed SteelCentral NetExpress 470, Руководство по модернизации и обслуживанию

Страница: 23 / 140

Upgrade and Maintenance Guide 23
Replacing Disk Drives R
eplacing xx70, Interceptor 9600, and SteelFusion Core 3500 Components
Important: It takes approximately 3 to 4 hours, depending on the system load, to rebuild a new disk drive. You can
configure the system to send an email to the administrator user when the disk drive has finished rebuilding.
Replacing Disk Drives in 2U Appliances with 2.5-inch Drives
2U SteelHead CX (CX5070 and CX7070) and SteelHead Interceptor 9600 appliances are equipped with
replaceable, hot-swappable 2.5-inch drives.
When replacing a drive, replace only one drive at a time. You must use approved disk drives. To order disk
drives, contact Riverbed Support at https://support.riverbed.com.
Note:
When you replace disk drives, you must wear a grounded ESD antistatic strap to protect the hardware against
electrostatic discharge. Make sure that the strap makes skin contact prior to handling equipment.
Caution:
Use caution when you remove or replace components; they can become hot to the touch.
To replace a 2.5-inch disk drive in the 2U appliances
1. Remove the bezel.
See “Removing and Installing the Bezel” on page 12 .
2. Identify the faulty disk drive.
The Web interface identifies the faulty disk drive. On a SteelHead, the Alarm Status page in the
Management Console identifies the faulty drive.
The disk drive LED is orange for failed drives.
The drives are numbered in ascending order from left to right (that is, starting with 0 on the left and
ending with 23 on the right).
– For the CX appliances, disks 0 and 23 are HDDs and disks 1 to 22 are SSDs.
– For the Interceptor 9600 appliances, disks 0 and 23 are HDDs.
Figure 1-16. Disk Drive Numbers