Riverbed SteelCentral NetExpress 470, Руководство по модернизации и обслуживанию

Страница: 12 / 140

12 Upgrade and Maintenance Guide
Replacing xx70, Interceptor 9600, and SteelFusion Core 3500 Components
Required Tools
Required Tools
You need the following tools and equipment to replace appliance components:

You must use approved components for the appliance to function properly. Installation of unapproved
components will result in boot failure. To order components, contact Riverbed Support at https://
support.riverbed.com.

An antistatic strap. When you replace appliance components, you must wear a grounded ESD
antistatic strap to protect the hardware against electrostatic discharge. Make sure that the strap makes
skin contact prior to handling equipment.

Use the magnetic Phillips screwdriver enclosed with your shipment to remove screws in the appliance.
The magnetic screwdriver ensures screws are not lost in the appliance.
Removing and Installing the Bezel
The following procedure describes how to remove and install the front bezel on 1U and 2U xx70 appliances.
To remove the bezel
1. If locked, unlock the bezel.
2. Remove the left end of the front bezel from the rack handle (letter A).
3. Pull the left side of the front bezel toward you to release the latches on the right end from the rack handle
(letter B).
Figure 1-1. Removing the Bezel on 1U and 2U xx70 Appliances
Note:
The bezel that ships with your appliance might look different from the bezel in the figure.
To install the bezel
1. Insert the tab on the right end of the front bezel to the rack handle (letter A).