Ricoh WG-20, Руководство по эксплуатации

Страница: 100 / 288

98
3
Taking Pic
tures
3
Use the four-way controller
(
45
) to select
i
or
h
and press the
4
button.
The self-timer lamp begins to blink
slowly and the camera is ready to take
a picture with the remote control.
When the camera detects a person’s
face, the Face Detection function is activated and the face detection
frame appears (p.71).
4
Point the remote control at the remote control receiver and
press the shutter release button on the remote control.
The focus frame turns green when the subject is in focus and
the camera takes a picture at the following timing.
When
i
(3-sec Remote Control) is selected:
The self-timer lamp and the macro lights blink quickly and
the camera takes a picture after about three seconds.
When
h
(0-sec Remote Control) is selected:
The camera takes a picture immediately.
•
The operating range is approx. 4 m (13 ft.) from the front of the camera
when using the remote control unit.
•
In
C
(Movie)
and (Underwater Movie) modes
, pressing
the shutter release button again stops the recording.
•
The camera takes a picture even if the focus is not achieved.
•
If the shutter release button on the camera is pressed halfway during
the countdown, the countdown stops. If the shutter release button on
the remote control is pressed again, the camera starts the countdown
again.
•
i
/
h
cannot be selected in
9
(Green) mode.
•
The self-timer lamp does not flash in
e
(Pet) mode.
MENU MENU
Cancel Cancel
MENU
Cancel
OK OK
OK OK
OK
OK
Drive Mode Drive Mode Drive Mode
Remote Control Remote Control Remote Control
WG20_OPM_ENG.book Page 98 Wednesday, February 5, 2014 2:20 PM