Ricoh TH-C1b, Руководство по обслуживанию

Страница: 100 / 433

10 February 2005 SCANNER UNIT
3-9
Replacement
Adjustment
Reassembling the Front Scanner Wire
1. Pass the end with the ball [A] through
the left square hole from the front.
2. Position the center ball [B] in the
middle of the notch, as shown by the
arrow.
3. Pass the ball end [A] through the
notch on the right.
4. Wind the end with the ring [C]
clockwise three times; wind the ball
end [A] counterclockwise five times.
NOTE: The two red marks [D] should
meet when you have done
this.
5. Stick the wire to the pulley with tape,
so you can easily handle the pulley
and wire during installation.
6. Install the drive pulley on the
shaft [E].
NOTE: Do not screw the pulley
onto the shaft yet.
7. Insert the ball end into the slit [F],
with the end going via the rear
track of the left pulley [G] and
the rear track of the movable
pulley [H].
B156R227.WMF
B156R228.WMF
[E]
[F] [G]
[H]
[A]
[B]
[C]
[D]