Ricoh A095, Руководство по обслуживанию

Страница: 544 / 680

BULLETIN NUMBER: 6645/6655-015 05/24/94
APPLICABLE MODEL: FT6645/6655
SUBJECT: KEY OPERATOR SERVICE TIPS
PROBLEM:
1. Paper misfeed at Tandem Tray press arms. 3. Paper misfeed at feed tray feed rollers
2. Paper misfeed in built-in LCT (1.5K LCT). 4. SC504
CAUSE:
1. 500 Sheets of thick paper are loaded into the left tray. When the paper stack is transported to
the right tray, some sheets may be caught by the press arms.
2. The end fence has been removed to allow A3 size paper feed. This prevents the top sheet,
which is returned to the tray by the FRR mechanism, from stopping at the correct position and
also results in too much load (because of heavier paper ) for the built-in LCT lift motor.
3. If adhesive labels are fed from the feed trays, the angle of the paper path may cause the label to
peel off the sheet and become stuck to the feed rollers.
4. The customer can load two stacks of copy paper in the Tandem Tray but they can NOT load the built-in
LCT in the same manner. Because there is no paper level detection for the improperly loaded area, the
LCT lift motor will continue to drive upward even though paper is already at the highest position
resulting in an SC504.
ACTION:
1. When using thick paper, do NOT stack the paper over the limit mark [A] even if there are less
than 500 sheets.
2. Do NOT remove the end fence [B] in the built-in LCT (1.5K LCT) to allow A3 size paper feed.
3. Adhesive labels should only be fed from the bypass feed tray; one sheet at a time.
4. Do NOT set copy paper at the left side of the end fence [B] of the built-in LCT (1.5K LCT).
[A]
Tandem Tray
[B]
1.5K LCT
Press Arms