Ricoh A095, Руководство по обслуживанию

Страница: 87 / 680

1 SP ADJUSTMENT
PAGE 3 PAGE 4
Item Function Note
❶
Changes the ON timing of the
registration clutch. (0.5 mm/step)
Adjustment standard: 0
±
2 mm
❷
Changes the OFF timing of the erase
lamp to adjust the leading edge erase
margin. (0.5 mm/step)
Adjustment standard: 3.5
±
2.5 mm
❸
Adjusts magnification in the paper feed
direction by adjusting the scanner
motor speed. (0.1%/step) Perform this adjustment when the optic
control PCB is replaced.
Adjustment standard: 100
±
1%
❹
Adjusts magnification perpendicular to
the direction of the paper feed. The
lens position in the full size mode is
changed. (0.1%/step) Perform this adjustment when the optic
control PCB is replaced.
Adjustment standard: 100
±
1%
❺
Enables or disables the 5 mm width
side edge erase. Default: No
❻
Adjusts the lens horizontal stop
position for each paper feed section.
(0.1 mm/step) Refer to 9.2 Side-To-Side Registration
Adjustment" in Section 5.
❻
Adjusts the lens horizontal stop
position for each paper feed section.
(0.1 mm/step) Only for A097 copier with RDH and
Finisher, the SP data for each feed
station should be the same as that for
Duplex tray. If not, the copy speed
when in alternate paper feed mode (1
sided original to 2 sided copy mode)
will be decreased. *
❼
Adjusts the lens horizontal stop
position to compensate for variations
of the side to side original position.
* Refer to 8.6.2 Side-To-Side Registration Adjustment "-Rough Adjustment-" in
Section 5. For other cases any SP data can be input. Refer to 8.6.2 Side-To-Side
Registration Adjustment in Section 5.
Rev. 7/94
(A097)
(A095/
A096)
❶
❷
❸
❹
❺
❻
❼
A095/A096/A097 4-10 FSM