M30870T2-CPE User’s Manual
4. Hardware Specifications
REJ10J0766-0400 Rev.4.00 February 16, 2006
IMPORTANT
Notes on MCU File:
Two types of MCU file are available for this product. Please use one of them as occasion demands.
(1) Using the MCU file "m30870.mcu"
When selecting AN00-AN07 or AN20-AN27 for analog input port select bits (bit2 and bit1 of 0394h), port
P15 can be used as an I/O port and intelligent I/O pin. However, external trigger mode (ADtrg and three-phase
timer B2) cannot be used. When using the "m30870.mcu", set all the SW5 switches of the M30870T-EPBM to
"OFF".
(2) Using the MCU file "m30870_ad.mcu"
For external trigger mode, use the "m30870_ad.mcu".
In this case, set analog input port select bits (bit2 and bit1 of 0394h) as follows.
- To select AN0-AN7 or AN150-AN157 for analog input port select bits:
Set all the SW5 switches of the M30870T-EPBM to "ON".
- To select AN00-AN07 or AN20-AN27 for analog input port select bits:
Setting the SW5 switches of the M30870T-EPBM enables to set analog input pin by each individual pin.
Set the pins used for the A/D conversion to ON and the pins not used to OFF.
Port P15 corresponding to a selected bit needs to be set to "input".
Notes on CE Declaration of Conformity:
This product complies with CE marking (EN55022: 1998 Class A, EN55024: 1998 ). Please use it with care
described below.
* Electrostatic Discharge Precautions must be taken when handling the product.
* Must not be used within 30 meters of a domestic radio or television receiver.
* For correct operation of this product, it is recommended that Mobile phones are not used within 10 meters of
this product system.
* This product should be powered down when not in use.
This product generates, uses, and can radiate radio frequency energy and may cause harmful interference to
radio communications.
If this product causes harmful interference to radio or television reception, which can be determined by turning
this product off or on, you are encouraged to try to correct the interference by one or more of the following
methods;
* Ensure attached cables do not lie across the probe board and converter board.
* Reorient the receiving antenna.
* Increase the distance between the product and the receiver.
* Connect the product into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or experienced radio/TV technician for help.
Attach the ferrite core included with this product close to the DC plug of the power cable. Without the ferrite
core it may cause interference.
The power cable should be wound around the ferrite core as shown in the figure, and close the ferrite core until
it clicks.
Page 93 of 102