M30870T2-CPE User’s Manual
3. Usage (Emulator Debugger)
REJ10J0766-0400 Rev.4.00 February 16, 2006
3. Usage (Emulator Debugger)
This chapter describes how to start up the emulator debugger and how to use the major windows.
3.1 Starting Up the Emulator Debugger (Init Dialog Box)
(1) MCU tab
1. Specifying the MCU file
2. Using or not using the address match break function
Cansel
Help
OK
Specifying the MCU file
Click the “Refer...” button.
A file selection dialog box will be displayed, so select the
desired MCU file.
- The MCU file contains the information specific to the
target MCU.
- The MCU file you have selected is displayed in the MCU
section of the MCU tab.
Cansel
Help
OK
Using or not using the address match break
function
Specify whether or not to use the address match break
function.
- To use the address match break function (default), select
the check box (marked by a check mark when selected).
In this case, the address match interrupt is used by the
emulator, and cannot be used in the user program.
- When not using the address match break function,
deselect the check box (check mark cleared). In this case,
the address match interrupt can be used in the user
program.
This option can be selected or deselected only when you are
starting up the emulator debugger.
Serial No.
Shows the currently connected emulators in list form. Select
the serial No. of the emulator you want to be connected.
Page 52 of 102
