32
l) Mounting the propeller
First slide the propellers (1) "dry" onto the motor shafts.
Make sure when installing the propellers that they are not wedged, twisted
or jammed, exert only gentle sensitive pressure to push them on. Do not
push the propeller until it locks in place on the shaft but rather leave a
sufficient distance to prevent the propeller from rubbing the dummy radi-
al engine.
There is a small opening (3) on the rear side of each of the motor nacelles
(2) through which you can insert the screwdriver included in the delivery
and, if necessary, apply light counter-pressure onto the motor.
In order to properly connect the propeller with the motor shaft, it is
necessary to pull it out once more. Apply a thin layer of superglue on the
motor shaft and push the propeller again into the original position.
Note!
Ensure that the superglue cannot leak along the motor driveshaft into the
motor bracket.
Figure 13a
Figure 13b
