PowerLift
by ReechCraft
18
secti
On
2
pREpARATION & INSpECTION
Begin the Daily Walk-Around Inspection starting at item one (1) as noted on
the diagram Figure 2-1. Continue around the machine checking each item in
sequence for the conditions listed in the following check list.
TO AVOID POSSIBLE INJURY MAKE SURE THERE IS NO POWER SUPPLIED TO
THE MACHINE DURING THE WALK AROUND INSPECTION. DO NOT OPERATE
MACHINE UNTIL ALL MALFUNCTIONS HAVE BEEN CORRECTED.
2.3
Daily Walk-Around Inspection
DANGER
NOTICE
CAUTION
WARNING
The following table outlines the periodic machine inspection and maintenance
recommended by ReechCraft. Consult local regulations for further requirements.
The frequency of inspections and required maintenance must be increased if
the machine is exposed to harsh conditions, increased use or if the machine is
used in a severe manner.
Table 2-1 Inspection and Maintenance
TYPE
FREQUENCY
PRIMARY
RESPONSIBILITY
SERVICE
QUALIFICATION
REFERENCE
Pre-start
Inspection
Before starting each
day or at shift change
Operator
User or Operator
Operator’s Safety
Manual
Frequent
Inspection
In service or out of
service for 3 mo. Or
purchased used
Owner, Dealer or
User
Qualified
Mechanic*
Operator’s Safety
Manual
Annual
Machine
Inspection
Every 12 Months
Owner, Dealer or
User
Qualified
Mechanic*
Operator’s Safety
Manual
Replacement
When Track is worn
or damaged
Owner, Dealer or
User
Qualified
Mechanic*
Operator’s Safety
Manual
NOTE:
Use this manual to perform inspections
NOTE: *
A person who has acquired training, qualifications or a combination
of these, the knowledge and skill enabling the person to inspect and repair the
machine to the level required by the complexity of the task.
