www.reechcraft.com/powerlift
888-600-6160
55
TROUBLE
PROBABLE CAUSE
REMEDY
Platform does not lift up from the fully lowered position - Drill motor starts
One or more interlocks are
engaged
Check to be sure all four outriggers are
properly installed, extended and stable.
Overload clutch is slipping
Be sure the rated load of 350 lbs (159 kg)
is not exceeded and that the platform
is free and clear of any obstruction or
interference.
One or more interlock pins are
wedged in the locked position
Lower platform to the fully lowered
position to relieve pressure, ensure all
leveling jacks are stable and bearing
equal weight.
Platform will not move when in elevated position - Drill motor starts
Intermediate mast section is
installed backwards with the track
section facing away from the
platform
Lower the platform and reinstall the mast
section with the track section facing the
platform.
One or more of the connector lock
levers are in the open position
interfering with the rollers
Lower the platform to expose the last
section of mast that was installed
and check to be sure both levers are
completely engaged and locked in
position.
The maximum height has been
attained causing interference with the
top termination plate
No remedy. System is functioning
properly.
Platform moves sluggishly
Drive Shaft brake is engaged
Depress the input shaft slightly before
applying power to release the brake.
Drill battery not fully charged
Charge battery
Drill has insufficient power or RPM
Be sure the drill contains a motor of 7
amps and 1200 RPM or more.
Machine does not wheel properly
One or more castors are in the
locked position
Unlock the castor
One or more castors are damaged
Replace the damaged castor
Climbing Unit jumps or lurches while elevating
Track is damaged and missing
teeth
Replace the track section*
*Performed by Authorized ReechCraft Service Center
Figure 7-1 Troubleshooting Guide
secti
On
7
TROuBlEShOOTING
