PowerLift
by ReechCraft
20
secti
On
2
pREpARATION & INSpECTION
NOTE:
On all components, make sure there are no loose or missing parts and that
everything is securely fastened. Make sure that there is no visible damage or excessive
wear.
1. Rear Wheels - Check for any debris stuck to or around the wheel or axle.
Make sure the axle bolts are tight and that the wheel spins freely.
2. Chassis - Check for cracks or corrosion especially at intersecting weld
joints. Make sure Bubble Level is clean and functioning. Be sure all four
outrigger pins are functioning properly. (See Figure 2-2)
3. Mast Sections - Check for cracks and corrosion. Make sure the
Cam Levers are not bent or misshapen and springs are functioning
properly. Make sure the track teeth are not worn, bent or misshapen.
Make sure the Cam Lever Lock is not bent or misshapen and the
spring is functioning properly. Make sure the Connector Pins are not
worn or damaged and the Connector Pin Openings are clean and
free of debris. Check to be sure the Cam Lever Shaft is not showing
excessive wear. (See Figures 2-1, 6-1 and 2-4)
4. Climbing Unit - Check for visible cracks or corrosion. Check guide
rollers for visible wear and proper alignment. Check to be sure all
fasteners and interlock pins are tight and functioning properly.
(See Figure 2-3)
Fig 2-2 - Bubble Level
Outrigger Retaining Pin
