RCT Power Storage DC 10.0, Руководство пользователя

Страница: 96 / 118

91
8.5.3 Connecting multiple RCT Power inverters in a LAN / WLAN network
If there are more than two Power Storage or Power Inverter devices to be linked in one system, connection over the S0
interface is no longer possible..
The devices must be connected over the LAN/WLAN interface using a network switch or a home network router.
The connected devices exchange information over this interface (e.g. house load, grid power, system peak power, power
reduction factor, max. permitted feed-in power and SOC target).
Please note: The devices can only be connected to a network if they are integrated into a home network router or a
network switch.
For integration into the home network router, please follow the corresponding procedure in the manual.
The integration with a fixed IP address is to be preferred. Configuring the home network router to assigning IP addresses
automatically with Dynamic Host Configuration Protocol (DHCP) can lead to a loss of connection and data.
If the devices connect over a network switch, integration with a fixed IP address is mandatory.
Fig. 1: Device networking via switch [4 clients] Fig 2: Device networking via router [4 clients]
Use the RCT Power APP to integrate multiple devices of RCT Power Storage and RCT Power Inverters into your home
network. Integration must be performed for the Master device and all slave devices separately.
The following integration instructions are based on using a fixed IP address and a Wi-Fi connection.
Please note: Software version 4464 or later must be installed for the RCT Power Inverter /RCT Power Storage to ensure
that the integration of multiple inverters into the home network is successful.