RCT Power Storage DC 10.0, Руководство пользователя

Страница: 8 / 118

3
2.2
Safety Procedures
The Power Storage DC was developed and tested in strict accordance with international safety regulations.
All safety instructions relating to electrical and electronic equipment must be complied with during installation, operation
and maintenance.
Danger to life or serious injury due to electric shock! High voltages are present in cables and
inner parts of the inverter if it is connected to the grid (AC / AC voltage source) or the solar
generator (DC / DC voltage source) is exposed to sunlight.
•
Qualified personnel must perform any work that involves wiring, connecting or opening
the inverter case.
•
Important: Both voltage sources (DC / solar generator and AC / grid) must be switched
off before any electrical work is carried out on the inverter.
•
Turn the DC Switch into the 0 position to disconnect the DC voltage.
•
Activate the circuit breaker or remove the fuse to disconnect the mains voltage (AC). Do
not reconnect until the work has been completed.
•
To disconnect the battery voltage, both voltage sources (DC / solar generator and AC /
mains) must be switched off and the battery switch on the master must be set to "0".
•
Allow a minimum of 10 minutes for the capacitors to fully discharge and then check the
voltage with a suitable measurement device.
•
Ensure that other persons stay away from cables and internal components.
Risk of injury due to electric shock!
Installation, service and maintenance work must only be carried out by a qualified electrician.
•
Do not drop the device. Do not expose it to knocks or pressure.
•
Only switch on again after all electrical work has been completed.
Risk of burns on hot parts of the inverter enclosure.
Parts of the inverter enclosure can become hot during standard operation.
•
Use care when touching the enclosure while the inverter is operating.
•
Do not cover the Power Storage DC (especially not the top).
•
All electrical installations must be carried out according to local and national standards
and guidelines.
•
Contact your local energy supplier or grid operator before connecting the inverter to
the grid.
•
Ensure that electrically conductive surfaces of the entire PV system are grounded to
prevent personal injury.
•
A malfunction can impair inverter safety. Do not operate or start the inverter if it shows
visible damage or if the displayed error message is unclear.
•
The inverter does not contain any parts to be serviced by the owner. Please contact
qualified personnel locally for servicing work on the inverter.
•
Only use devices and accessories approved by the manufacturer. Do not make any
changes to the device. Do not remove the type plate.