RCT Power Storage DC 10.0, Руководство пользователя

Страница: 73 / 118

68
7.2.2.3.3.1.1 Battery properties (Installer Area!)
Use to view and retrieve the serial numbers, software versions and parameters of the Power Battery or Power Battery Stacks.
7.2.2.3.3.2 Interfaces
Use to configure the interfaces for peripheral devices.
7.2.2.3.3.2.1 Multifunctional relay
The multifunction relay can be configured in the operation modes "Load" or "Alarm".
In the mode "Load", the relay switches on when a certain power threshold is reached. Threshold Power and time delay for
the switch on/switch action can be configured.
In the mode "Alarm", the relay switches on in the event of an inverter fault. This can be used, e.g. to power on a warning
lamp
7.2.2.3.3.2.2 Digital I/O´s ( Installer Area! )
Use to configure the Digital I/O interfaces. You can change settings for the external display or configure the interface for
pulses from energy meters to control the output power of the inverter. They can also be configured as inputs for emergency
stop signals (especially for use in Italy).
7.2.2.3.3.2.3 RS485
Use to configure the RS485 interface for connecting a data logger or an electricity meter.
7.2.2.3.3.2.4 External active power reduction (Installer Area!)
Use to configure Ripple Control Signal receiver. Pre-configured according German EEG.
7.2.2.3.3.3 Normative parameters ( Installer Area!)
Use to view and change the country-specific parameters set up during configuration of the inverter and battery.
7.2.2.3.3.3.1 AC Level (Installer Area!)
Use to view and set AC voltage levels and corresponding switch-off times. The default settings correspond with the general
mains grid specifications. They can only be changed after consultation with the local utility company.
7.2.2.3.3.3.2 AFI parameters ( Installer Area!)
Use to view and configure parameters for the AFI residual current circuit breakers.
7.2.2.3.3.3.3 DC-component (Installer Area!)
Use to configure the max. DC components in the feed-in current.
7.2.2.3.3.3.4 NSM (Installer Area! )
Use to view and configure normative grid support functions [Cosphi (P), fixed Cosphi, P (f), Q (U) and P (U)]. The default
settings correspond with the general mains grid specifications. They can only be changed after consultation with the local
utility company.
7.2.2.3.3.3.5 Switch-on conditions (Installer Area!)
Use to view and configure the normative switch-on conditions (voltage level, frequency level, test time). The default settings
correspond with the general mains grid specifications. They can only be changed after consultation with the local utility
company.